Industrial Automation Tools

Translate current, voltage, and PLC raw counts into engineering units.

This subgroup will hold signal scaling, NE43, burden resistor, and standards-oriented instrumentation helpers.

Model RTD, thermocouple, and other process sensor behaviors.

Use this subgroup for temperature conversion, calibration, and sensor-focused engineering utilities.

Solve passive network, timing, and board-level interface calculations.

Use these tools for resistor, capacitor, timer, filter, and low-voltage interface checks that commonly support control-panel electronics and troubleshooting.

Decode component markings and other compact engineering references.

Use this subgroup for lookup-style tools where the primary job is decoding, interpreting, or cross-referencing markings and reference standards.

Estimate running current, starting demand, and overload settings.

This subgroup covers motor electrical sizing work that typically feeds protection, feeder, and starter decisions.

Model regenerative braking and high-inertia deceleration behavior.

Use this subgroup for braking resistor, energy dump, and other dynamic deceleration utilities tied to motion and drives.

Size conductors, evaluate voltage drop, and check raceway fill.

Use this subgroup for conductor area, drop, ampacity, and cabling capacity checks in panels and field wiring.

Estimate system power, supply sizing, and upstream capacity.

This subgroup covers phase power, transformer, supply, and backup runtime calculations that anchor power distribution design.

Screen interrupting duty, branch protection, and panel fault resilience.

Use this subgroup for breaker, fuse, fault current, and SCCR-oriented engineering decisions.

Model harmonic impact and reactive power correction.

This subgroup handles power factor correction and harmonic distortion studies used for supply health and system conditioning.

Estimate cabinet heat load and enclosure cooling needs.

Use this subgroup for thermal management and enclosure-level environmental checks.